导弹总体结构多学科鲁棒设计优化
DOI:
CSTR:
作者:
作者单位:

1.北京航空航天大学;2.北京航空航天大学 能源与动力工程学院;3.澳门科技大学;4.应用数学与计算物理研究所 北京

作者简介:

通讯作者:

中图分类号:

V235.1

基金项目:


Surrogate-Assisted Collaborative Robust Multidisciplinary Design Optimization of a Missile Overall Structure
Author:
Affiliation:

1.Beihang University;2.School of Energy and Power Engineering,Beihang University;3.Macau University of Science and Technology;4.Institute of Applied Physics and Computational Mathematics

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对细长导弹总体结构在跨声速飞行阶段易受气动载荷、结构刚度和参数不确定性共同影响而产生低阶弹性振动风险的问题,提出一种融合Kriging代理模型、Sobol全局灵敏度分析和协同优化的多学科鲁棒设计优化方法。首先建立气动、静力学和结构动力学三学科耦合分析框架,采用单向流固耦合获得气动载荷向结构响应的传递关系,并以质量单元和转动惯量等效方法构建结构动力学简化模型。随后基于最优拉丁超立方抽样构建Kriging代理模型,通过Sobol总效应指数筛选关键变量,降低高维代理模型输入空间。最后对比多学科可行法和协同优化法的确定性优化效果,并在协同优化框架中引入不确定性传播和一阶固有频率均值-标准差鲁棒目标。结果表明,简化模态模型前5阶相对误差均小于5%,单次模态计算时间由约6 h降至约10 min;协同优化将简化模型一阶固有频率由132.70 Hz提高至173.01 Hz,提升30.4%;鲁棒优化设计的名义一阶固有频率为148.05 Hz,阻力系数、最大应力和质量分别为0.4738、29.11 MPa和178.04 kg。10000组蒙特卡洛样本验证表明,鲁棒方案一阶频率均值为142.18 Hz、标准差为0.808 Hz,频率、阻力、应力和质量的6σ区间均满足约束。该方法可在有限高保真样本条件下实现导弹总体结构动力学性能提升与参数波动抑制的协同设计。

    Abstract:

    To reduce the low-order elastic vibration risk of a slender missile structure under coupled aerodynamic, static, dynamic and parametric uncertainty effects, a robust multidisciplinary design optimization method integrating Kriging surrogate modeling, Sobol global sensitivity analysis and collaborative optimization is proposed. A coupled aerodynamic-static-structural dynamic framework is established, in which one-way fluid-structure interaction is used to transfer aerodynamic pressure loads to the structural model. A dynamic equivalent model based on mass elements and rotational inertia is then developed to improve modal-analysis efficiency. Kriging surrogate models are constructed using optimal Latin hypercube sampling, and Sobol total-effect indices are used to screen dominant variables and reduce input dimensions. Deterministic optimization results obtained using multidisciplinary feasible and collaborative optimization architectures are compared, and a robust objective combining the mean and standard deviation of the first natural frequency is further introduced into the collaborative optimization framework. The equivalent modal model keeps the relative errors of the first five elastic modes within 5%, while reducing a single modal analysis from about 6 h to about 10 min. Collaborative deterministic optimization increases the first natural frequency from 132.70 Hz to 173.01 Hz. The robust optimal design achieves a nominal first natural frequency of 148.05 Hz, with a drag coefficient of 0.4738, a maximum stress of 29.11 MPa and a mass of 178.04 kg. Monte Carlo verification with 10000 samples shows that the robust design has a frequency mean of 142.18 Hz and a standard deviation of 0.808 Hz, and all 6σ intervals satisfy the prescribed constraints. The proposed method enables simultaneous frequency improvement and fluctuation suppression for missile overall structures using limited high-fidelity samples.

    参考文献
    相似文献
    引证文献
引用本文

李吾嘉,樊江,邓珺艺,等. 导弹总体结构多学科鲁棒设计优化[J]. 科学技术与工程, , ():

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-06-30
  • 最后修改日期:2026-10-14
  • 录用日期:2026-10-30
  • 在线发布日期:
  • 出版日期:
×
关于《科学技术与工程》全新官方网站正式上线的通知公告
关于抵制伪造参考文献学术不端行为的声明
关于规范使用生成式人工智能的声明
亟待确认版面费归属稿件,敬请作者关注