温州软粘土不排水真三轴试验的研究
DOI:
作者:
作者单位:

浙江海洋学院,浙江海洋学院,温州大学 建筑与土木工程学院,浙江工业大学 岩土工程研究所

作者简介:

通讯作者:

中图分类号:

tu

基金项目:

国家自然科学基金(51109118);浙江省自然科学基金(LY14E090001)


The reaserch of Wenzhou clay in undrained true triaxial test
Author:
Affiliation:

Architecture and civil Engineering college,Wenzhou University,Institute of Geotechnical Engineering,Zhejiang University of Technology

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用英国GDS真三轴仪,针对原状温州软粘土进行恒定小主应力 下不同中主应力系数b的固结不排水试验。在三维应力状态下,研究不同中主力条件下粘土的强度变形特性,利用相同应力路径下主应力旋转对比试验反映土的各向异性特性。研究结果表明:在轴向压缩(TC)试验中,随着加载的进行,偏应力逐渐增大并趋于平稳,并随中主应力系数b呈现先增大后减小的趋势,b=0.8时出现峰值;广义剪应力峰值呈现先增大后减小的趋势,峰值在0.6~0.8之间;轴向压缩试验(TC)加载过程中,当b=0.4时,中主应变接近为0,可视为平面应变情况;在b=0.4~1.0之间时,剪缩效应受中主应力系数b影响较明显;b=1.0时,轴向压缩(TC)试验破坏强度高于轴向拉伸(TE)试验的破坏强度,其应力应变响应有显著不同;在π平面上,Lade-Duncan准则对试验点的拟合精度优于Mohr-Coulomb准则和Matsuoka-Nakai准则。

    Abstract:

    A series of consolidated undrained true triaxial tests on Wenzhou undisturbed soft clay samples with different b values under constant minor principal stress are carried out through the GDS true triaxial apparatus. Under the three dimensional stress state,the strength-deformation characteristics of clay in the different conditions of intermediate principal stress will be researched, as well the anisotropy features taking advantage of the principal stress rotation experiments. The test results show :in the axial compression (TC) test, the shear of deviatoric stress increased gradually and leveled off, as the intermediate principal stress coefficient b increases, the shear stress peak value showed a trend of increases at first then decreases; The generalized shear stress peak value showed a trend of decrease after the first increase, the peak value between 0.6 ~ 0.8; When b = 0.4, the intermediate principal strain is close to 0,which can be treated as plane strain condition;When b Between 0.4 and 1.0, the shear shrinkage effect affected by the principal stress coefficient b distinctly;when b=1.0, the failure strength in Axial compression (TC) test is higher than that of axial tensile (TE) test, which the stress and strain response is significantly different;the fitting precision of the results in the π plane is close to Lade-Duncan criterion, which is better than that of Mohr - Coulomb criterion and Matsuoka - Nakai criterion.

    参考文献
    相似文献
    引证文献
引用本文

毛浩燃,王亚军,施佳豪,等. 温州软粘土不排水真三轴试验的研究[J]. 科学技术与工程, 2016, 16(14): .
Mao Haoran,王亚军,Shi Jiahao, et al. The reaserch of Wenzhou clay in undrained true triaxial test[J]. Science Technology and Engineering,2016,16(14).

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2015-12-23
  • 最后修改日期:2016-03-16
  • 录用日期:2016-02-23
  • 在线发布日期: 2016-05-18
  • 出版日期:
×
律回春渐,新元肇启|《科学技术与工程》编辑部恭祝新岁!
亟待确认版面费归属稿件,敬请作者关注