首页|期刊简介|投稿指南|分类索引|刊文选读|订阅指南|资料|样刊邮寄查询|常见问题解答|联系我们
刘洪亮,李美求,潘 力,等. 压裂工况下T型三通冲蚀影响数值模拟[J]. 科学技术与工程, 2020, 20(10): 3893-3897.
liu hongliang,pan li,et al.Numerical simulation of erosion effect of t-type tee under Fracturing Condition[J].Science Technology and Engineering,2020,20(10):3893-3897.
压裂工况下T型三通冲蚀影响数值模拟
Numerical simulation of erosion effect of t-type tee under Fracturing Condition
投稿时间:2019-07-17  修订日期:2020-01-02
DOI:
中文关键词:  T型三通  液固两相流 冲蚀速率  数值模拟
英文关键词:T-type tee  solid-liquid two-phase  flow erosion  rate numerical  simulation
基金项目:国家科技重大专项
           
作者单位
刘洪亮 长江大学机械结构强度与振动研究所
李美求 长江大学机械结构强度与振动研究所
潘 力 长江大学机械结构强度与振动研究所
江宇潇 长江大学机械结构强度与振动研究所
摘要点击次数: 92
全文下载次数: 52
中文摘要:
      研究水力压裂工况下T型三通的冲蚀。基于FLUENT内置的DPM模型探究流速、质量流量、粒子直径、进出口流通方式对T型三通冲蚀的影响。结果表明:内部流速与冲蚀率的变化关系呈现幂函数关系,且曲线中存在冲蚀影响临界流速。液体流速小于临界流速,流速的增加引起冲蚀程度增加较不明显,当流速超过临界流速,引起冲蚀率的急剧增加。支撑剂颗粒粒径与冲蚀率的变化关系呈正相关。汇流状态下的冲蚀率最大,分流状态下的冲蚀率最小。汇流状态下的冲蚀率最大是分流状态下的30.7倍;既不分流也不汇流状态下的最大冲蚀率可以达到了分流状态的冲蚀率的5.4倍。
英文摘要:
      The erosion behavior to T-type tee under fracturing condition was studied through the DPM model built in FLUENT, the erosion of T-type tee is influenced by flow velocity, mass flow rate, particle diameter, inlet and outlet circulation mode. The relationship between internal velocity and erosion rate shows a power function and erosion affects critical velocity in the curve. The increase of the flow rate causes less obvious increase of erosion degree when the liquid flow rate is less than the critical flow rate, and the erosion rate increases sharply when the flow rate exceeds the critical flow rate. There is a positive correlation between the particle size of proppant particles and the erosion rate. The erosion rate is the largest in the confluent state and the smallest in the distributary state. The erosion rate in confluent state is 30.7 times higher than that in diversion state. The maximum erosion rate, which is under the condition of neither diversion nor confluence, can reach 5.4 times of the erosion rate under the condition of diversion.
查看全文  查看/发表评论  下载PDF阅读器
关闭
你是第30512220位访问者
版权所有:科学技术与工程编辑部
主管:中国科学技术协会    主办:中国技术经济学会
Tel:(010)62118920 E-mail:stae@vip.163.com
京ICP备05035734号-4
技术支持:本系统由北京勤云科技发展有限公司设计

京公网安备 11010802029091号