首页|期刊简介|投稿指南|分类索引|刊文选读|订阅指南|资料|样刊邮寄查询|常见问题解答|联系我们
董建辉,李海军,涂昌鹏,等. 倾斜煤层采动影响下的挤压变形区移动变形特征分析[J]. 科学技术与工程, 2020, 20(10): 3881-3886.
董建辉,et al.Analysis on the Moving Deformation Characteristics of Extrusion Deformation Zone under the Influence of Mining in Inclined Coal Seam[J].Science Technology and Engineering,2020,20(10):3881-3886.
倾斜煤层采动影响下的挤压变形区移动变形特征分析
Analysis on the Moving Deformation Characteristics of Extrusion Deformation Zone under the Influence of Mining in Inclined Coal Seam
投稿时间:2019-07-11  修订日期:2019-10-30
DOI:
中文关键词:  倾斜煤层采动  挤压变形 数值模拟 FALC3D
英文关键词:inclined coal seam mining Extrusion deformation Numerical simulation FALC3D
基金项目:黔科合支撑[2017]2814项目、黔科合平台人才[2017]5402项目、成都大学引进人才启动项目(2081917010)
              
作者单位
董建辉 成都大学
李海军 成都理工大学
涂昌鹏 重庆地质矿产研究院
邱 茂 成都理工大学
陈 静 成都大学
摘要点击次数: 143
全文下载次数: 54
中文摘要:
      本文以重庆南桐矿区为工程背景,通过三维数值模拟方法,对倾斜煤层在三种不同开采宽度工况下上覆岩层移动挤压变形区特征进行了研究。结果表明:采宽由80 m增加到160 m时,煤层与岩层交接处应力变化较小,挤压变形区地表下沉速度较为缓慢;采宽由160 m增加到240 m时,煤层与岩层交接处应力变化非常显著,挤压变形区地表产生明显下沉;不同的开采工况下,挤压变形区沉陷位移都会出现一个峰值,且位于开采区下山方向,挤压变形区沉陷值受水平应力影响较小,走向和倾向方向的沉陷值以该峰值曲线呈中心对称。
英文摘要:
      The overlying strata movement and deformation characteristics of inclined coal seam under three working conditions of different mining width were studied by using three-dimensional numerical simulation method.The results show that when the mining width increases from 80 m to 160 m, the stress at the interface between coal seam and rock layer changes little, and the surface subsidence rate in the extrusion deformation zone is slow.When the mining width increases from 160 m to 240 m, the stress changes at the interface between the coal seam and the rock layer are very significant, and the surface in the extrusion deformation zone causes obvious subsidence.Under different mining conditions, there is a peak value of subsidence displacement in the extrusion deformation area, which is located in the downhill direction of the mining area. The subsidence value in the extrusion deformation area is less affected by the horizontal stress, and the subsidence value in the strike and trend directions is symmetric with the peak value curve.
查看全文  查看/发表评论  下载PDF阅读器
关闭
你是第30507000位访问者
版权所有:科学技术与工程编辑部
主管:中国科学技术协会    主办:中国技术经济学会
Tel:(010)62118920 E-mail:stae@vip.163.com
京ICP备05035734号-4
技术支持:本系统由北京勤云科技发展有限公司设计

京公网安备 11010802029091号