首页|期刊简介|投稿指南|分类索引|刊文选读|订阅指南|资料|样刊邮寄查询|常见问题解答|联系我们
敖文君,阚 亮,王成胜,等. 适合海上B油田聚驱后非均相在线调驱性能评价[J]. 科学技术与工程, 2019, 19(31): 134-139.
Ao Wenjun,Kan Liang,Wang Chengsheng,et al.Performance evaluation of heterogeneous on-line control and flooding for offshore B oilfield after polymer flooding[J].Science Technology and Engineering,2019,19(31):134-139.
适合海上B油田聚驱后非均相在线调驱性能评价
Performance evaluation of heterogeneous on-line control and flooding for offshore B oilfield after polymer flooding
投稿时间:2018-12-25  修订日期:2019-05-14
DOI:
中文关键词:  高含水  聚合物驱  非均相在线调驱  调剖性能  驱油效率
英文关键词:High water cut  Polymer flooding  Heterogeneous combinationSflooding  Profile control performance  Oil displacement efficiency
基金项目:中国海洋石油总公司CNOOC-KJ 135 KJXM NFGJ 2016-04,十三五国家重大科技专项2016ZX05025-001-003资助
                    
作者单位
敖文君 中海油能源发展股份有限公司工程技术分公司
阚 亮 中海油能源发展股份有限公司工程技术分公司
王成胜 中海油能源发展股份有限公司工程技术分公司
吴彬彬 中海油能源发展股份有限公司工程技术分公司
黎 慧 中海油天津分公司
田津杰 中海油能源发展股份有限公司工程技术分公司
侯岳 中海油能源发展股份有限公司工程技术分公司
摘要点击次数: 150
全文下载次数: 18
中文摘要:
      针对渤海B油田聚合物驱后储层非均质性增强,注水突进严重,产油量低等问题,通过室内实验评价研究,优选了两种非均相在线调驱体系FJX-1和FJX-2,开展了海上油田聚驱后,高含水期阶段非均相在线调剖、调驱性能评价及驱油效率分析。结果表明,聚合物与FJX-1、FJX-2在线调驱体系的封堵效率分别为61.42%、83.45%、93.17%,FJX-2调驱体系的复合黏度、弹性模量均好于聚合物和FJX-1调驱体系,表明其封堵性能与粘弹性能最好,对比液流转向能力,注入聚合物与FJX-1、FJX-2在线调驱体系后,高、低渗透率层的产液分数比分别从87:23、89:21、88:12下降到最低的61:39、48:52和35:65,在后续水驱中FJX-2在线调驱体系的岩心的高、低渗透率层的产液分数比依然可以达到66:34,FJX-2在线调驱体系对高渗透率层封堵效果明显。驱油实验可以看出,三种体系驱过程中最低含水率分别为:54.58、52.97、44.39。聚合物驱后继续FJX-1、FJX-2体系驱,可以提高采收率值分别为6.32%和11.84%,对比可知,最佳的调剖与调驱段塞组合为调剖(1500mg/L PL+1500mg/L JLJ)+调驱(1500mg/L RY+300mg/L PPG),非均相复合体系的调剖与调驱性能,通过对高渗透率层的有效封堵,不仅使中、低渗透率储层中的原油得到动用,同时对残留在储层内的部分原油也发挥了驱替效果。同时,矿场试验也表明,非均相复合驱在海上油田具有广阔的发展前景。
英文摘要:
      Aiming at the problems of enhanced reservoir homogeneity, severe injection water breakthrough and low oil production after polymer flooding in Bohai B oilfield, through laboratory research and evaluation, three heterogeneous composite systems: FJX-1, FJX-2 and FJX-3, were optimized, and the profile control and profile control performance evaluation, and displacement efficiency analysis of heterogeneous combination flooding in high water cut stage after polymer flooding in offshore oilfield have been carried out. The results show that the plugging efficiency of the three heterogeneous composite systems FJX-1, FJX-2 and FJX-3 are 85.21%, 83.45% and 93.17% respectively, and the plugging performance and viscoelastic performance are better than those of the polymer system. Comparing and analyzing the liquid flow diversion ability of FJX-3 and polymer, after injecting FJX-3, the liquid production fraction ratio of high and low permeability layer decreased from 88:12 to 35:65 after water flooding,indicating that the heterogeneous composite system has obvious plugging effect on high permeability layer.The oil displacement experiment shows that compared with polymer flooding, the enhanced oil recovery values of the three heterogeneous composite systems are 6.32%, 3.59% and 11.84%, respectively. The best combination of profile control and flooding slug is profile control (1500mg/L PL + 1500mg/L JLJ) + profile control and flooding (1500mg/L GN + 300mg/L PPG). The heterogeneous composite system has better profile control and profile control performance. By effective blocking of high permeability layer, the crude oil in the medium and low permeability reservoirs is used, also some crude oil remaining in the reservoir has been displaced. Meanwhile, field tests also show that heterogeneous composite flooding has broad prospects for development in offshore oilfields.
查看全文  查看/发表评论  下载PDF阅读器
关闭
你是第26662490位访问者
版权所有:科学技术与工程编辑部
主管:中国科学技术协会    主办:中国技术经济学会
Tel:(010)62118920 E-mail:stae@vip.163.com
京ICP备05035734号-4
技术支持:本系统由北京勤云科技发展有限公司设计

京公网安备 11010802029091号